Vought XF5U Flying Flapjack

Item#: MPXF5U

MSRP Price: $299.95

Factory Direct Price: $199.95

A developed version of the original V-173 prototype, the XF5U-1 was a larger aircraft. Of all-metal construction, it was almost five times heavier, with two 1,600 hp Pratt and Whitney R-2000 radial engines. The configuration was designed to create a low aspect ratio aircraft with low takeoff and landing speeds but high top speed.

The XF5U looks like it should not be able to fly, as its wing area looks so small. Normally, a wing with such a low aspect ratio will suffer from very poor performance due to the degree of induced drag created at the wingtips, as the higher pressure air below spills around the wingtip to the lower-pressure region above. In a conventional aircraft, these wingtip vortices carry a lot of energy with them and hence create drag. The usual approach to reducing these vortices is to build a wing with a high aspect ratio, i.e. one that is long and narrow. However, such wings compromise the maneuverability and roll rate of the aircraft, or present a structural challenge in building them stiff enough. The XF5U overcomes the tip vortex problem using the propellers to actively cancel the drag-causing tip vortices. The propellers are arranged to rotate in the opposite direction to the tip vortices, which retains the higher-pressure air below the wing. Since this source of drag is eliminated, the aircraft will fly with a much smaller wing area, and the small wing yields high maneuverability with greater structural strength.

The propellers envisioned for the completed fighter were to have a built-in cyclic movement like a helicopter's main rotor, with a very limited ability to tilt up and down to aid the aircraft in maneuvering. The problem with this arrangement on the XF5U-1 was that the propeller's radius covered nearly the entire frontal area of the aircraft. A typical wing installation of any forward-firing weapons such as machine guns, cannon, or missiles would be virtually impossible. Although the prototype was unarmed, a combination of machine guns and cannons would have been installed under the nose. Also, the radar would have to be mounted forward of the propellers to prevent interference. An ejection seat was fitted to allow the pilot to clear the massive propellers in the event of an in-flight emergency.

Your model will be made exactly as shown in the photographs. If you would like to change this model in any other way, please visit the Custom Model section of our website to commission a personalized model to be built.